Asko WM70 Manuel de service télécharger pdf (Page 29)

Service manual WM70

Fault indications WM70.3

The below faults are indicated in plaintext in LCD 1. The table shows the indication in all languages and language variations.

LCD 1 Cause Action

Over ﬂow fault, Overﬂow

Fault, Over ﬂow fault,

Överfyllnad, Overløbsfejl,

Overﬂom, Ylitulviminen,

Trop plein, Überfüllt, Troppo

pieno, Desborde, Пeрeлив

вoды, Te veel water

Too much water in the

machine.

Service action:

Check the machine’s level system, inlet valve

and drain pump. Make sure that there is no

leaks.

The drain pump is on,

without any water in the

machine.

Service action:

The overﬂow protection at the bottom of

the machine is activated (not all models).

Make sure that there is no leaks (water on

the machines base)

Water outlet fault, Water

Outlet Fault, Water outlet

fault, Uttömningsfel,

Udpumpningsfejl, Vannutløp,

Vedenpoistovika, Défaut ,

Wasserablauffehler, Uscita

acqua, Fallo, Слив вoды,

Waterafvoer fout

1. The drain pump has

been activated more

than 3 minutes. There is

still water in the machine.

2. The wash cycle is

interrupted and the

program is cleared.

Customer information:

1. Check that no objects are stuck in the

drainage hose outlet.

2. Check that the drain pump is not blocked

by foreign objects.

3. Check that there are no kinks in the

drainage hose.

Service action:

1 .If the pump only runs for a short while

(approximately 20 seconds), this indicates

a fault in the level system. Check the level

sensor and hoses.

2. Check wiring and voltage to the pump. If

necessary, replace the pump and/or control

3. After implementing corrective action, run

the Drain program or press the Key button

Water inlet fault, Water

Inlet Fault, Water inlet

fault, Vattenintagsfel,

Vandindtagsfejl, Vanntilførsel,

Vika vedenotossa, Défaut,

Wasseraufn.-fehler, Entrata

acqua , Fallo , Haбoр вoды,

Watertoevoer fout

If the correct water level

is not reached within 5

minutes, the wash cycle

is interrupted.

Customer information:

1. Check that the tap on the water pipe is

open.

Service action:

1. Check that the lter in the machine’s water

intake is not blocked.

2. Check the inlet valve. If necessary, replace

the valve.

3. Check voltage to the inlet valve. If there is

no voltage, this could be due to a fault in the

level system, wiring or control unit.

Security fault, Security

Sys Fault, Security

fault, Lucköppningsfel,

Sikkerhedsfejl, Sikkerhetsfeil,

Vika turvajärj., Erreur

sécurité, Sicherh.-fehler, Err.

sis.sicurezza, Fallo sistema

seguridad, Oшибкa сис.

бeзoп., Deurslot fout

The door is open. Close the door.

1 2 ... 24 25 26 27 28 29 30 31 32 33 34 ... 47 48

Commentaires sur ces manuels

Pas de commentaire

Asko WM70 Manuel de service Page 29

Commentaires sur ces manuels

Produits connexes et manuels pour Machines à laver Asko WM70