Asko T743C Instructions d'exploitation télécharger pdf (Page 24)

5.

Connect ground (center) wire of power supply

cord to the center, silver-colored terminal

screw. Tighten screw.

6.

Connect the other wires to outer screws.

7.

Tighten the strain relief screws.

8.

Replace terminal box cover on back of dryer.

9.

Plug dryer into wall receptacle.

10.

Turn power on at breaker/fuse box.

Connecting a 4-wire Power Cord

Warning!

Before starting this procedure, be sure the power

is turned off at the breaker/fuse box.

Power Supply Cord

You will need a 4-wire power supply cord with four

No. 10 copper wires and a matching 4-wire

receptacle of NEMA Type 14-30R, as illustrated

below.

The fourth wire must be identified with a white

cover and the ground conductor by a green cover.

To connect a 4-wire power cord to the dryer,

follow the steps below.

Note

The numbers in the illustration below correlate

to the step numbers.

1.

Turn the power off at the breaker/fuse box.

2.

Remove terminal block cover.

3.

Use the strain relief attached below the

terminal block opening.

4.

Remove center terminal block screw.

4

6

7

8

5.

Remove ground wire (green with yellow

stripes) from external ground connector screw

and remove from center terminal block.

6.

Connect ground (green) wire of cord to external

ground conductor screw.

7.

Connect neutral (white) wire of cord under

center screw of terminal block.

8.

Connect the other wires to outer screws.

9.

Tighten the strain relief screws.

10.

Replace terminal box cover on back of dryer.

11.

Plug dryer into wall receptacle.

12.

Turn power on at breaker/fuse box.

Customer Care Center24

1-800-898-1879

www.askousa.com

Installation instructions

1 2 ... 19 20 21 22 23 24 25 26 27 28

Commentaires sur ces manuels

Pas de commentaire