Adjusting the feet
Screw the feet in or out so that the tumble dryer
is steady and balanced on the floor or on the
washing machine. Then tighten the lock nuts.
Condensed water
Install the dryer so the condensed water will
continuously flow into a drain or sink. To do this,
follow the instructions below:
1.
Disconnect the short hose (1) from the blue
connection. (It’s okay to let the hose hang
down.)
2.
Connect the rubber hose supplied with the
dryer to the blue nipple (2).
3.
Run the hose to a drain or sink, as illustrated
(3).
Note
The drain hose must not be more than 40” above
the floor.
Electrical installation
Warning!
The receptacle on the rear of the machine is
designed to accommodate ASKO washers
ONLY (rated 208–240 V.) To use this receptacle,
you must use the ready-fitted plug supplied with
the washing machine or an equivalent.
ASKO washers rated 208–240 V have two
internal fuses of 15 A each.
The machine should only be connected to a
grounded wall socket.
Warning!
This appliance must be properly grounded. Refer
to the “Important Safety Instructions” for
grounding instructions.
The power supply cord must be grounded. If the
machine is to be used in a wet area, the supply
must be protected by a residual current device.
Connection to a permanently wired supply point
must be made only by a qualified electrician. As
supplied: Single-phase, 230 V, 60 Hz, 2500W
heater rating 30 A circuit required
Remove cover to
access terminal box.
(Requires a 20-Torx
screwdriver.)
Customer Care Center22
1-800-898-1879
www.askousa.com
Installation instructions
Commentaires sur ces manuels