Asko DBI664IXXLS Instructions d'exploitation télécharger pdf (Page 10)

1 Press the button once to activate Delayed Start. Press the button

several times – or hold it in – to set the desired number of hours.

2 Press Start/Stop and close the door. The timer counts down and

the dishwasher starts after the selected delay.

If you want to cancel the Delayed Start option, open the door and press

and hold the main power switch until the display turns off.

TIP!

Activate the setting High temperature to improve the dishwashing

results. Energy consumption is slightly increased.

START

STOP

Starting the dishwasher

Press and hold Start/Stop until the display shows "Program started,

close door in 4 sec". This indicates that the dishwasher is ready to

start. Close the door properly within four seconds, otherwise the

dishwasher will not start.

If the dishwasher is not started or the door is not closed within 2 minutes

of the last button press, the machine switches off.

Time remaining

Once you have chosen a program, program mode, and options, the

time the program took when last used is displayed.

Status light™

Status light

The status light at the bottom on the dishwasher provides information

by means of 3 different colors.

Blue - Do not load

The program has started.

Red - Do not load

The detergent compartment lid has been opened to add detergent.

Flashing red indicates a problem. See also the chapter Troubleshooting.

Green - Unload

The dishwashing program is finished. Standby light for 60 minutes.

Stopping or changing a program

If you want to change the program after starting the dishwasher, open

the door then press and hold Start/Stop for three seconds. Add more

detergent if the lid of the detergent dispenser has opened. Then choose

a new program, press Start/Stop, and close the door within four

seconds.

WARNING!

The dishwasher door must not be open while a program is in progress

according to UL Standards. If the door is opened, "Program paused"

is shown on the display. If you want the dishwashing program to

continue, press Start/Stop and close the door immediately. If you

want to cancel the dishwashing program, press and hold the main

power switch until the display turns off.

If the dishwasher is turned off due to a

power failure

If the program was not finished, the interrupted program resumes when

power is restored.

NOTE!

During drying, the program is interrupted if the power is cut or the

door is open for more than 2 minutes.

Once the program has finished

Once the program has finished and the door is opened, "Ready"

appears on the display.

At the end of the program, one short signal will sound. Chapter Settings

describes how to change this function.

Moreover, the end of the program is indicated by the status light turning

green.

The dishwasher switches off automatically after the program ends.

To minimize the risk of leaks, we recommend that you turn off the water

supply valve if away from home for an extended period of time.

How to get the best drying results

• Fully load the dishwasher.

• Angle dishes with hollows, such as cups, so that the rinse water

will run off. This is also important for plastic items.

• Top up with rinse aid or increase the rinse aid dosage level.

• Activate the Extra Dry option.

• Open the door a little once the program has finished.

• Allow the dishes to cool before unloading the dishwasher.

Unloading the dishwasher

Hot porcelain is more fragile. Leave the dishes to cool in the dishwasher

before unloading them.

Unload the lower basket first to avoid any water drops from the upper

basket falling onto the dishes in the lower basket.

1 2 ... 5 6 7 8 9 10 11 12 13 14 15 ... 23 24

Commentaires sur ces manuels

Pas de commentaire

Asko DBI664IXXLS Instructions d'exploitation Page 10

Commentaires sur ces manuels

Produits connexes et manuels pour Lave-vaisselle Asko DBI664IXXLS